Transactional Security: Setup
The following are the requirements and prerequisites for using Transactional Security.
- Eagle Licensing must activate option 1345 "Point to Point Encryption on system" in Options Configuration
- Your Eagle must be running Release 24.1 or higher
- You must be using the Epicor Payment Gateway
- You must be using Ingenico iSC250 pin pads
- You must download RBA 12.01 or higher from Device Configuration to the iSC250 pin pad. WARNING: This download can take 45 minutes per pin pad if you are not yet on RBA 3.33. To view the job aid on updating your signature capture pad to the current RBA click HERE.
-
- At each terminal with an ISC250 attached, do the following:
-
- Open Eagle Browser
- Click "Utilities" in the left pane
- Click "Device Configuration"
-
-
- Double Click on the line where "Signature Capture" is listed
-
-
- In the grid, click on the line where "ISC250 RBA 12" is listed
-
-
- Wait until it is finished
- Go back to the Credit/Debit Pad screen and click "Options"
-
-
- Choose “P2PE” from the Device Configuration options menu for the iSC250 pin pad
-
-
- Repeat these steps for all terminals with an ISC250 attached
- You must be processing payment cards with one of the following:
-
- FDMS
- Global
- Chase Paymentech
- RBS Worldpay (Available in March 2016)
- EPX
- If you currently have stored credit card numbers for you AR customers you can run a utility to convert them to tokens. Click here to view the procedure.
Setup Instruction and Tokenization Utility Instructions are in Online Help and Training on Demand